Speciality Mould Base Services
Our "Speciality" grade of mould base is best classified for one or multiple demands on the following stringent criteria:
Critical tolerance within 0.02mm or lower
Plate flatness and parallelism from 0.01mm to 0.02mm
Plate interchangeability
Hardened treatment, stress relief, sub-zero
Good dimensional stability
Good cooling efficiency
Corrosion resistant steel
Minimum deflection under high camp tonnages and infection pressures
Minimum maintenance (eg. clean room application)
A high-performance mould of SPI class 101
Customer's Mould
Stringent Mould Application
Hot Runner Compact Mould
- Preform mould up to 72 Cavities
Fast-Cycle Injection Mould
- Below 7 seconds per cycle
High-Performance Cubic Mould
- Molding cycles of one million or higher
- Under stringent mould making requirement,
SPI Class 101
High-Temperature Engineering Plastic Mould
- Exotic resin material, PEI Polyetherimide with 30% carbon fiber
- Mould temperature 150°C - 180°C
Large & Complex Mould
- Automotive mould
- 3D profile matching for direct mould
- Mould size (X,Y) up to 2,000mm
- Plate thicker (Z) up to 570mm
- Weight up to 3 tonnes per plate
- Deep-hole drilling up to 1,000mm with deflection of 0.1mm per 100mm & depth-to-diameter ratio of 100:1
Hardened-Treatment Mould
- Connector mould
- Mould base within tight dimensional tolerance of 0.01mm
- Undergone process of heat treatment (48 to 52 Hrc), stress release or sub-zero treatment
Medical/Optical Mould
- Cleanroom moulding
- Corrosion resistant steel
- Mould base within tight dimensional tolerance of 0.01mm